How to install an Aluminium Backsplash is the question of many homeowners these days. The answer is simple, it's really very easy. In this article, we will give you the complete guide to install your own Aluminium backsplashes. Just follow the instructions given below.
First of all, remove the existing wall coverings from the walls. The most important part of this process is to be able to reach all the walls at one go. To do this, lay a sheet of plywood on the floor, then get ready the tools necessary for the job. The basic tools required for this task are paintbrushes, a saw, a level and an angled brush. Before beginning, make sure you have everything ready.
Take off the old covering wallpaper from the walls, the topmost part should be removed and the two sides of the wall should be lifted and laid on the floor. Once the walls are ready, make sure you lay down a flat sheet of plywood, then place a piece of plywood behind the wall paper, making sure it is not too high so that you can reach all the walls. Next, use a level to make sure the wall paper is even across the entire wall. Once the wallpaper is level, start removing the old coating, which is now covered by the new one.
You can now begin laying the new material, using a wooden dowel, or old material like newspaper, as a frame. The most important thing that you need to pay attention to is to use good quality tools, and work with the material very gently. Make sure that you lay the material flat, and not too close together. If you do not want the material to stick to the walls, you can then use an angled brush, or use sand paper to remove some of the sticks from the surface.
Once you have done your installation, place the metal pieces back into place and re-attach them to the wall. If you don't have access to the walls, then you can use a piece of paper as a guide and make sure everything is right. Once the installation is done, clean the wall again with a bit, because there could be some residue left behind, if not cleaned properly. When everything is clean and dust-free, paint over the entire wall with the same color of paint as before.
Another tip, when installing Aluminium, you should always remember to leave enough space between the wall and the edge of the shower. You may also need to trim the extra space in case your shower curtain does not fit well, or else the shower door does not close properly. This should be done before the finish coat of the paint has been applied. The extra space between the edges of the shower should be taken care of so that the new material does not get in the way of the new cover.
If you decide to change the colors of the paint, you may need to apply the second coat at least two coats, but this depends on the style and design of your bathroom. It is very important to get the coat of paint, especially if the look is not exactly the same as the original one. You should never apply two coats of a different color or design of paint in one day and never wait till after the first coat has dried before reapplying it. After the first coat of paint is dry, make sure the walls are properly sealed with silicone sealer, and clear tape the entire wall, and then apply the second coat of paint.
One last tip is to clean the Aluminum after the installation. Do not clean it with hot water and soap, or other chemicals, as this will damage the material, and the aluminum, and it may also cause further damage. If you need to re-applying of the Aluminum backsplashes, then use a non-abrasive, mild detergent spray on the surface after it has dried for about five minutes. Once it has dried thoroughly, you can now apply the finishing coat of the aluminum paint and then let it dry completely.
Gallery of 9 Things You Won’t Miss Out If You Attend Aluminum Backsplash | aluminum backsplash
Tags: #aluminum backsplash #aluminum backsplash behind stove #aluminum backsplash for kitchen #aluminum backsplash for stove #aluminum backsplash home depot #aluminum backsplash lowes #aluminum backsplash panels #aluminum backsplash tile #aluminum backsplash tiles lowes